FORD 351W IGNITION WIRING 1985
Ignition su Amazon - Scopri tutte le novità
AdRisparmia su Ignition. Spedizione gratis (vedi condizioni)
I have finished putting a 351W into my 1985 Ford F-150. I
I have finished putting a 351W into my 1985 I have finished putting a 351W into my 1985 Ford Could there be a problem in the wiring by the ignition5/5The only parts that could not be allowing no spark to go into the distributor to the plug wires would be a defective cap or rotor. You could check the rotor with an ohm meter as well as the coil tower in the cap for continuity.if you dont have 12 volts to the positive side of the coil, then you wont have spark, if this runs to the ignition switch, then you either have a bad switch, or you do not have power to the ignition switch,TimTHERE ARE SEVERAL LEGS OFF THE IGNITION SWITCH, check that red wire at the switch, if it has power to it with the key on, then it is a break somewhere in the wire from the switch to the coil, if it does not have power, then its a bad switch,TimI have seen conditions where the coil will lose power when going back to run from the start position. I'm going to forward this to one of our senior Ford techs who may be more familiar with this specific issue. No need to reply to this someone should be with you shortly.Hi, my name is XXXXX XXXXX the coil is firing and you have spark to the distributor, but no spark to the plugs, is this correct?have you actually checked for spark out of the coil wire, you can remove it from the distributor, and lay it close to any metal piece and crank it over, and see if it has spark, can you do this?ok, then you DONT have spark out of the coil, when the key is on, do you have 12 volts to the Positive side of the coil?ok, so there is no voltage at the positive side of the coil, what color is the wire you are checking?
Ford 302, 351w How to set Ignition Timing - YouTube
How to set ignition timing for a small block ford.Author: Engine Factory Custom Crate EnginesViews: 300KVideo Duration: 7 min